![]() ![]() *** Note if you see an error and the FireHD Reboot and do the "Apps and Data Optimization" at the Welcome Install Screen Powerdown the FireHD and enter Bootloader again.ī) Enter "sudo. Proceed to step 10 if there no problems, but it didn't work for me. brick.sh (note that you are actually bricking your fire tablet in order to recover)ĩ) Check Display output for the "Disconnect USB and Powerdown" Message and do so when prompted. You will see the black screen with "Fastboot" in the lower corner.Ĩ) Open Terminal from "brick-douglas" folder an enter "sudo. Sudo apt install python3 python3-serial adb fastboot dos2unixĤ) Reboot FireHD8 to Recovery (Power Off device, then hold VolUp + Power)Ħ) Reboot to Bootloader. Honorable mention to Opec who actually got the instructions right so I modified his instructions a little to fit everything in.Ī) amonet-douglas-v1.2.zip from first Page of this Thread:ī) brick-douglas.zip from first Page of this Thread:ġ) Boot from a live version of linux (I used Ubuntu mate Lts 20.04) or you can install linux in your computer.Ģ) Run the following commands to install tools It is hard to find a one with the firmware 5.6.4.0 or lower so this is how I got it to work. Recently there was a sale on this Fire hd 8 gen 7 for $20 at Woot so I brought it so I tried to hack. Number Start (sector) End (sector) Size Name Other partition table is at sector 30777343 First usable sector is 34, last usable sector is 30777310 This partition table begins at sector 2 and ends at sector 33 brom-payload/build/payload.bin = 0x4888 bytes * * * If you have a short attached, remove it now * * *
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |